Detailed Product Description

SP-12 Acrylic Floor Coating System

SP-12 is a two component, seamless, high weather resistance floor coating system with the following properties:

        Attractive,excellent decorating effect

        Hard wearing and dust free environment

        Easy to clean and maintain

        High weather resistance and anti-slip surface

SP-12 is recommended for floors where both a high level of weather resistance and decoration effect are required. It is ideal for:Outside parking lot, tennis or basket ball court and so on.

Technical Data

Note:All the technical data stated in the above sheet are based on the tests; practical data may vary due to circumstances beyond our control.

Direction of Use

Surface preparation

     The compressive strength of the concrete substrate should not be less than 25N/mm², the best application temperature is between 10~25.The air humidity must not be higher than 80%, the moisture content of the substrate shall not be higher than 8.

     Correct substrate preparation is critical for optimum performance. Surfaces should be sound, clean, dry and free from loose particles, oil, grease, and other contaminants

     Clean oil, grease by special detergent. Cement laitance, loose particles, pitch and other contaminants must be removed from the surface by sand-blasting. The alkalinity and porosity of the surface must also be considered.

Primer SP-01A as a primer is adapted to seal the substrate. According to the oil absorption of substrate, a second sealer coat may also be required.

Putty Scraping the putty, SP-01A: SP-01B: silicon powder=1:1:3-4.

Pot life 0.5h at +25C

Cleaner Clean tools and equipments using a special detergent SP-01S before the coating curing.

Packaging

SP-01 A: 15kg per drum

SP-01 B: 15kg per drum

SP-12 A: 15kg per drum

SP-12 B: 15kg per drum

SP-01 S: 15kg per drum

Shelf life

12 months stored in original container, at a dry enclosed place at temperatures between 15 to 35 without exposure to direct sunlight. 

Health and safety information

Protective measures SP-12 contains certain chemicals which can cause skin irritation. Wear gloves, masks while handling the product, washing thoroughly after handling. Should skin contact occur, wash immediately with soap and water.

During application and curing in closed rooms, adequate fresh air ventilation must be provided. Keep away from open flames including welding.

In case of accidental eye contact, wash with a large quantity of water and immediately seek medical advice.

For detailed health, safety, environment recommendations, please consult and follow the instruction on the product material safety data sheet 

Disclaimer                

The information given in this sheet is not intended to be exhaustive. Any person using the product without first making further written enquiries as to the suitability of the intended purpose does so at his own risk and we can accept no liability of the product for any loss or damage arising out of such use. The information contained product development. Product data are subject to change without notice and become void five years from the date of issue.

SP-12 is for professional use only.

ISSUED in May 2006